From f5ca2dbf7f12c6a8c382843c34df04565f616e80 Mon Sep 17 00:00:00 2001 From: Riku Viitanen Date: Mon, 15 Jan 2024 20:10:40 +0200 Subject: [PATCH] serprog: clean up documentation * serprog.h doesn't exist, so refer to .c source instead * in the doc, no other command has S_CMD_ prefix either Change-Id: Ic83e7fd80840f2db0b006935a964721da0388068 Signed-off-by: Riku Viitanen Reviewed-on: https://review.coreboot.org/c/flashrom/+/80499 Tested-by: build bot (Jenkins) Reviewed-by: Anastasia Klimchuk --- Documentation/serprog-protocol.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt index d58b8e98e..3d4aa1a9c 100644 --- a/Documentation/serprog-protocol.txt +++ b/Documentation/serprog-protocol.txt @@ -84,7 +84,7 @@ Additional information of the above commands: lower than the one requested. If there is no lower frequency available the lowest possible should be used. The value chosen is sent back in the reply with an ACK. - 0x15 (S_CMD_S_PIN_STATE): + 0x15 (S_PIN_STATE): Sets the state of the pin drivers connected to the flash chip. Disabling them allows other devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can remain attached to the flash chip even when the board is running. The user is responsible to @@ -103,4 +103,4 @@ Additional information of the above commands: In addition, support for these commands is recommended: S_CMD_Q_PGMNAME, S_CMD_Q_BUSTYPE, S_CMD_Q_CHIPSIZE (if parallel). -See also serprog.h. +See also serprog.c