Add support for RayeR SPIPGM hardware as described in http://rayer.ic.cz/elektro/spipgm.htm

To use the RayeR driver, run
flashrom -p rayer_spi -V

Known bugs/limitations:
- Won't compile/work on non-x86 architectures.
- Will always use direct port I/O access.

Log follows:

flashrom v0.9.2-r1039 on MS-DOS 7 (i686), built with libpci 3.1.5, GCC 
4.3.2, little endian
Calibrating delay loop... OK.
Initializing rayer_bitbang_spi programmer
Using port 0x378 as I/O base for parallel port access.
...
Probing for Macronix MX25L1605, 2048 KB: probe_spi_rdid_generic: id1 
0xc2, id2 0x2015
...
Found chip "Macronix MX25L1605" (2048 KB, SPI) at physical address 
0xffe00000.
...
No operations were specified.

Corresponding to flashrom svn r1093.

Signed-off-by: Carl-Daniel Hailfinger <c-d.hailfinger.devel.2006@gmx.net>
Acked-by: Martin Rehak <rayer@seznam.cz>
Acked-by: Michael Karcher <flashrom@mkarcher.dialup.fu-berlin.de>

spi.c

@@ -121,6 +121,15 @@ const struct spi_programmer spi_programmer[] = {
 	},
 #endif
 
+#if CONFIG_RAYER_SPI == 1
+	{ /* SPI_CONTROLLER_RAYER */
+		.command = bitbang_spi_send_command,
+		.multicommand = default_spi_send_multicommand,
+		.read = bitbang_spi_read,
+		.write_256 = bitbang_spi_write_256,
+	},
+#endif
+
 	{}, /* This entry corresponds to SPI_CONTROLLER_INVALID. */
 };