This is a SPI hardware interface with a display (https://spidriver.com/),
connected as an FT230X USB serial device at a fixed baud rate of 460800.
Firmware: https://github.com/jamesbowman/spidriver
Protocol: https://github.com/jamesbowman/spidriver/blob/master/protocol.md
Most of the implementation is copied from the Bus Pirate programmer.
Tested with a SPIDriver v2 by reading FM25Q128A flash memory on Linux.
Change-Id: I07b23c1146d4ad3606b54a1e8dc8030cf4ebf57b
Signed-off-by: Simon Arlott <flashrom@octiron.net>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/86411
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Peter Marheine <pmarheine@chromium.org>
Reviewed-by: Anastasia Klimchuk <aklm@chromium.org>
Add support for the WCH CH347, a high-speed USB to bus converter
supporting multiple protocols interfaces including SPI. Currently only
mode 1 (vendor defined communication interface) is supported, mode 2
(USB HID communication interface) support will be added later. The code
is currently hard coded to use CS1 and a SPI clock of 15 MHz, though
there are 2 CS lines and 6 other GPIO lines available, as well as a
configurable clock divisor for up to 60MHz operation. Support for these
will be exposed through programmer parameters in later commits.
This currently uses the synchronous libusb API. Performance seems to be
alright so far, if it becomes an issue I may switch to the asynchronous
API.
Tested with a MX25L1606E flash chip
Signed-off-by: Nicholas Chin <nic.c3.14@gmail.com>
Change-Id: I31b86c41076cc45d4a416a73fa1131350fb745ba
Reviewed-on: https://review.coreboot.org/c/flashrom/+/70573
Reviewed-by: Thomas Heijligen <src@posteo.de>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
The ASMedia ASM106x series is a PCIe-SATA controller chip. It supports
an attached SPI flash chip that can contain configuration and PCI option
ROM. The interface is a simple shifter accessed via PCI config space,
up to 4 bytes at a time. Add a programmer driver for it.
Tested on a G536PCE1061V11 IO-PCE1061-V1.1 PCIe card, and
a MPCE2ST-A01 VER006S mini-PCIe card, both with chips marked ASM1061,
both enumerate as:
01:00.0 SATA controller [0106]: ASMedia Technology Inc. ASM1062 Serial ATA Controller [1b21:0612] (rev 02) (prog-if 01 [AHCI 1.0])
Subsystem: ASMedia Technology Inc. ASM1062 Serial ATA Controller [1b21:1060]
Change-Id: I591b117be911bdb8249247c20530c1cf70f6e70d
Signed-off-by: Alex Badea <vamposdecampos@gmail.com>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/73037
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Thomas Heijligen <src@posteo.de>
Add a new programmer driver for the DirtyJTAG project (a USB-JTAG
firmware for STM32 MCUs).
Successfully tested with DirtyJTAG 1.4 running on an Olimex STM32-H103
development board and a SST25VF020B SPI flash chip.
Change-Id: Ic43e9a014ed7d04e429e73b30c9dcfdde1a78913
Signed-off-by: Jean THOMAS <virgule@jeanthomas.me>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/67878
Reviewed-by: Felix Singer <felixsinger@posteo.net>
Reviewed-by: Angel Pons <th3fanbus@gmail.com>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
The chip targeted by the `lspcon_i2c_spi` programmer is a Parade PS175.
Rename the programmer to match the chips vendor / family instead of the
generic LSPCON protocol. Remove the `_i2c_spi` ending in preparation to
become an opaque master. The chip is visible on an Acer Chromebox CXI4.
https://www.paradetech.com/products/ps175/https://www.acer.com/ac/en/US/content/series/acerchromeboxcxi4
TEST: `make CONFIG_PARADE_LSPCON=yes` and
`meson build -Dconfig_parade_lspcon=true` produces flashrom
binaries with the parade_lspcon programmer included.
Change-Id: I9148be6d9162c1722ff739929ca5e181b628dd57
Signed-off-by: Thomas Heijligen <src@posteo.de>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/65547
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Felix Singer <felixsinger@posteo.net>
Reviewed-by: Angel Pons <th3fanbus@gmail.com>
Add a spi_master interface supporting MediaTek MST9U ISP mode.
Autodetect the bus type via I2C_FUNC_I2C, and use the appropriate
read/write commands, in case the MST9U is attached to smbus.
TEST=Successfully programmed SPI on test hardware.
Change-Id: I24adb14e7b4f7160e1c3ff941774064d5a81e820
Signed-off-by: Neill Corlett <corlett@google.com>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/61288
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Edward O'Callaghan <quasisec@chromium.org>
Best efforts were made to upstream older Chromebook support for good
intentions for folks interested. However, we no longer have the hardware
available to test and maintain the code as the hardware is now end of
life. Therefore the code state has sadly fallen into a unknown state.
BUG=none
BRANCH=none
TEST=builds and ninja test passes
Signed-off-by: Victor Ding <victording@google.com>
Change-Id: I535b6380846734c999474519e9e60a73eb6a2ec4
Reviewed-on: https://review.coreboot.org/c/flashrom/+/56476
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
Best efforts were made to upstream older Chromebook support for good
intentions for folks interested. However, we no longer have the hardware
available to test and maintain the code as the hardware is now end of
life. Therefore the code state has sadly fallen into a unknown state.
BUG=none
BRANCH=none
TEST=builds and ninja test passes
Signed-off-by: Victor Ding <victording@google.com>
Change-Id: I3f40db22c42c04ce029c4defd837e05ebb550c9b
Reviewed-on: https://review.coreboot.org/c/flashrom/+/56475
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
Allows us to move the individual entries into their respective driver files.
Change-Id: Ifbb0ee4db5a85b1cd2afeafe4dca838579f79878
Signed-off-by: Thomas Heijligen <thomas.heijligen@secunet.de>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/52945
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Nico Huber <nico.h@gmx.de>
